Winter Pool (Answer)

Hi Frank,

Calling a pool company is certainly one option, but if you have time to do it yourself, it’s not too hard. It will also save you some money.

Based on what you told me, I think these basic instructions will be what you need:

 Vacuum all debris from your pool.
 Remove all accessories and ladders.
 Let the filter run until pool water runs clear.
 Check chlorine level, it should be 3 ppm and the Ph should be 7.5.
 Add the winterizing chemicals (follow the directions of the chemicals you purchase).
 Bring water level to just below the skimmer opening.
 Remove skimmer weir door and basket.
 Install skimmer winter cover plate and put the cap back on.
 Tie an air pillow in the center of the pool (this will help hold up the cover).
 Install winter cover (secure cover with tie-downs or cables or what ever method your pool uses).
 If you are in a windy area, you can add a couple of inches of water to the top of the pool cover.
 Disconnect pump and filter, drain, and store indoors (if sand filter, remove the top valve, drain and cover).
 Shut off gas to water heater (or shut off electric if electric heater)
 Drain water from heater, and cover.
If your pool is equipped with a bottom drain, it must be disconnected at the valve and elevated above the water level. Then it needs to be plugged with a cap that has an air valve fitting, so you can pump air into the pipe to force out water.
If the pool has a light, the bulb should be removed and stored.

I hope this will help you.

Thanks for the Question

Al

Questions can be sent to: agarrett@hometeaminspection.com